• Onix Wedge, is set that includes wedges and clips for tile leveling usage.
• It is applied by hand. Special pliers are used in the final compression process required to bring the tiles to the same level.
• Its application is easy and practical.
• There are clips in different sizes from 1.5 mm to 4 mm to create the wanted joint Groove.
• The wedge is compatible with any size of clip and is designed for continuous use.
• Onix Wedge is ment to use on tiles that have a tickness between 3mm and 15 mm. designed for floor and walls.

After putting the tile on the glue, place the clip next of the tile with the flat part of the clip at the bottem.

After placing the clips, move on to the next tile. Depending on the size of the tile, it may be necessary to place 2 or more clips between the tiles.

In average it is recommended to use 1 clip for each 20cm.

The wedges are placed in the slot of the clips by hand tightening so as not to cause the holders to break.

With adjustable pliers, the wedges are tightened and the leveling process is completed.

Disassembly is as easy as application. After application, wait for the glue to dry and make sure the system is fully prepared for removal. It is recommended to wait longer for large sized tiles with high deformation. Thus, it helps to reach minimum levels of concave and convex deformations in tiles.For dismantling, use a rubber mallet that does not damage the tile surfaces and leave no traces. In addition, the wedges are removed with a slight foot impact.

During dismantling, take care to hit the wedges parallel to the joint grooves. Keep the wedges for later usage. Wedges are designed for continuous use.